Appendix A — Command Reference
This appendix lists the Debug80 commands used in Book 1. Command titles are taken from the current Debug80 extension manifest.
Project Setup
| Command |
Use |
| Debug80: Create Project |
Create debug80.json, starter source and build setup for the selected folder. |
| Debug80: Select Workspace Folder |
Choose the folder Debug80 should treat as the active project. |
| Debug80: Select Active Target |
Choose the target launched by F5 and the panel build button. |
| Debug80: Set Program File |
Bind an .asm or .z80 source file to the current target. |
| Debug80: Configure Project |
Change project settings through the extension command flow. |
| Debug80: Open Project Configuration Panel |
Open the project configuration panel for the active folder. |
Debug Sessions
| Command |
Use |
| Debug80: Start Debugging |
Build and start the selected target. |
| Debug80: Restart Debugging (Current Target) |
Rebuild and relaunch the active target. |
| Debug80: Open Debug80 View |
Reveal the Debug80 panel in the Run and Debug sidebar. |
| Command |
Use |
| Debug80: Show Terminal Panel |
Open the terminal panel. |
| Debug80: Send Terminal Input |
Send text to the terminal path. |
| Debug80: Show TEC-1 Panel |
Open the TEC-1 panel. |
| Debug80: Show TEC-1 Memory Panel |
Open the TEC-1 memory panel. |
ROM And Hardware
| Command |
Use |
| Debug80: Open ROM Source |
Open bundled or workspace ROM source material for the active profile. |
| Debug80: Copy Bundled Assets into Workspace |
Copy bundled ROM and listing assets into the project folder. |
| Debug80: Send HEX to Board via CoolTerm |
Send the active target’s HEX file to hardware through CoolTerm. |